BEFORE SERVICE BLOCK
- [ ] Turn OFF/BYPASS Fire Alarm
- Turn Key
- User 1 → User 2 (20) → Acknowledge
- Turn Key
- [ ] Turn CO2 ON (x2)
- Located backstage
- Stage right by production suite / Lefty loosey
- Stage left behind drums / Lefty loosey
- [ ] Turn Breakers ON
- iPad is on rack under lighting console
- Password: 0815 → Lyntec RPC (LT)→Activate
- [ ] Power lighting console ON
- Power button/toggle is located on the back right of the boards/consoles
- [ ] Turn lighting monitors ON
- Power button is located on the back right side of the monitor at the bottom
- [ ] Fade Grandmaster fader UP
- This is the Blackout (B.O.) Fader, located on the right side of the left board/console
- [ ] Fade Service fader UP and select
- [ ] DMX Network Active (click “Network DMX if Alone” button to turn it green)
- Setup →Network Protocols →Network DMX if Alone
- [ ] Lamp R2 Beams ON
- [ ] Verify that this week’s songs have been loaded into fader
- [ ] Check to see that all fixtures are working
- [ ] Check to see that all house lights zones (including backstage & entry) are set correctly for service
- [ ] While Running through cues during rehearsal check the positioning of the Beams, Spots & Washes
- Make sure that none of them are hitting the LED walls or audience in the face, also watch stadium seating
- [ ] Run through all of the non-worship cues
AFTER REHEARSAL
- [ ] Set Auditorium look to Walk - In
AFTER SERVICE BLOCK
- [ ] Lamp OFF R2 Beams
- [ ] Turn CO2 OFF (x2)
- Located backstage
- Stage right by production suite / Righty tighty
- Stage left behind drums / Righty tighty