BEFORE SERVICE BLOCK
- [ ] Turn CO2 ON
- Located backstage
- Stage left behind drums / Lefty loosey
- [ ] Power lighting console ON
- Power button/toggle is located on the back right of the board
- [ ] Turn lighting monitors ON
- Power button is located on the back right side of the monitor at the bottom
- [ ] Fade Grandmaster fader UP
- This is the Blackout (B.O.) Fader, located on the right side of the left board/console
- [ ] Fade Service fader UP and select
- [ ] Verify that this week’s songs have been loaded into fader
- [ ] Check to see that all fixtures are working
- [ ] Check to see that all house lights zones are set correctly for service
- [ ] While Running through cues during rehearsal check the positioning of the Spots & Washes
- Make sure that none of them are hitting the LED wall, side screens, or audience in the face, also watch balcony seating (currently N/A)
- [ ] Run through all of the non-worship cues
AFTER REHEARSAL
- [ ] Set Auditorium look to Walk - In
AFTER SERVICE BLOCK
- [ ] Turn CO2 OFF
- Located backstage
- Stage left behind drums / Righty tighty
- [ ] Clean up area
- [ ] Leave comments as needed